Open Access Journal

Manuscript submission

Volume 62 (2011), issue 2

Assessment of Wood Surface Quality Obtained During High Speed Milling by Use of Non-Contact Method


This paper presents the method of surface quality evaluation at high-speed milling of wood. The effects of specific parameters of machining on the surface quality are described and results are presented of experiments carried out on selected tree species, where the effects of specific parameters on the surface quality were noted. The surface quality is evaluated by a non-contact method using a confocal sensor (CLA), which processes the results of the roughness measurement, Talysurf CLI 1000. It can be concluded that this method could actually be used for the evaluation of the surface quality.


Faculty of Forestry and Wood Technology

DRVNA INDUSTRIJA Scientific Journal of Wood Technology

ISSN 0012-6772 (Print) / ISSN 1847-1153 (Online)

Faculty of Forestry and Wood Technology University of Zagreb, Svetošimunska 25, 10000 Zagreb, Hrvatska - Croatia
Tel: +3851 2352 430, E-mail:
Editor-in-Chief: Prof. Ružica Beljo-Lučić, Ph.D. E-mail:
Cookie settings