Open Access Journal

Manuscript submission

Volume 73 (2022), issue 3

Feed Cutting Force Component in Up and Down Sawing of Pine


The monitoring of cutting force components is one of the possibilities to control machining processes from the point of view of its stability, machine tool spindle or cutting tool loading. This paper presents and compares the results of experimental longitudinal sawing of pine wood with 4 saw discs with different teeth number (16 and 24) and rake angle (10° and 20°) during up (conventional) and down (climb) cutting with different revolutions (4000 min-1, 5000 min-1, 6000 min-1) and feed speed (15 m/min, 20 m/min, 25 m/min). The signal was obtained from Quart 3-components piezoelectric dynamometer.


Faculty of Forestry and Wood Technology

DRVNA INDUSTRIJA Scientific Journal of Wood Technology

ISSN 0012-6772 (Print) / ISSN 1847-1153 (Online)

Faculty of Forestry and Wood Technology University of Zagreb, Svetošimunska 25, 10000 Zagreb, Hrvatska - Croatia
Tel. (+385 1) 235 24 30, E-mail:
Editor-in-Chief: Prof. Ružica Beljo-Lučić, Ph.D. E-mail: